Trinity Anglican Church, Streetsville Cemetery
Monument sizes at a glance
| Lot or section | Memorial | Width | Thickness | Height | Notes |
|---|---|---|---|---|---|
| Single lot | Upright monument (overall) | up to 14 in | - | up to 36 in | As printed: max 3 ft high and 14 in (35.6 cm) 'width'. 14 in is very narrow for a headstone and may mean the base depth front to back; confirm with the cemetery. |
| All monuments | Upright monument (headstone / die) | - | at least 8 in | - | At least 10 in (25.40 cm) if the monument is over 42 in tall. Dies 8 in thick and under 34 in wide must be doweled. |
| All monuments (over 42 in overall) | Upright monument (headstone / die) | - | at least 10 in | - | |
| All monuments | Upright monument (base) | - | - | at least 6 in | Granite base at least 6 in high with at least a 3 in border on all sides; max width set by the lot width. |
| Single lot (marker or footstone) | Flat marker | up to 24 in | at least 4 in | - | The by-law gives two sizes without saying which is side to side; the larger is recorded as width and the smaller is the head-to-foot length. At least 4 in thick. |
| Double lot (marker) | Flat marker | up to 66 in | at least 4 in | - | The by-law gives two sizes without saying which is side to side; the larger is recorded as width and the smaller is the head-to-foot length. At least 4 in thick. |
| Cremation lot | Cremation memorial | up to 16 in | at least 4 in | - | Only 16 x 10 in granite markers in designated cremation areas; at least 4 in thick. |
| Footmarkers in front of a monument | Flat marker | up to 20 in | at least 4 in | - | Up to 4 per grave. Max 12 x 20 in; the by-law calls 12 in the 'standard width', but we record 20 in as side to side and 12 in as head to foot. Confirm orientation. |
Width is side to side, thickness is front to back, height is above the ground.
Ask our assistant about your plot
Monument rules in plain English
- Anglican parish cemetery of Trinity Church, Streetsville, run by its Trustees under the 2023 by-laws (amended November 2023).
- Lots are sold as singles and doubles. A single grave may have one headstone and four footmarkers; a double lot one upright monument and up to eight footmarkers.
- Single-lot monument: max 3 ft high; the by-law also prints a 14 in 'width', which may mean depth, so confirm with the cemetery.
- Dies at least 8 in thick (10 in if over 42 in tall); thin narrow dies must be doweled; every monument must resist 100 lb of sideways force.
- Granite base at least 6 in high with a 3 in border on all sides; base width is limited by the lot width.
- Monuments only on lots designated for them, centred at the head of the lot.
- Flat markers and footstones: granite only, flush, at least 4 in thick. Single lot max 18 x 24 in, double lot 18 x 66 in, cremation lot 16 x 10 in.
- Footmarkers in front of a monument may not exceed 12 x 20 in. Any flat marker wider than the standard 12 in can only go in after a full burial.
- Concrete foundations are required for all monuments and markers, installed by the approved supplier at your cost; none from November 15 to April 1.
- Candle holders or vases must be mainly bronze or stainless steel. All inscriptions, including niche covers, need pre-approval.
- Temporary markers may be provided by the cemetery for 6 months only.
- A Request for Installation form with full dimensions and the Care and Maintenance levy must accompany every monument.
- Always confirm with the cemetery office before ordering.
Read the full bylaws (on the cemetery's website)
Bylaws can change and some are read automatically. Always confirm sizes with the cemetery office before ordering. Monaco Monuments checks your cemetery's rules for you as part of every order.
Ready to start? Fill out our free intake form (no cost or obligation) or call us at (905) 392-0778. Fill out the intake form