Highland Park Cemetery
Monument sizes at a glance
| Lot or section | Memorial | Width | Thickness | Height | Notes |
|---|---|---|---|---|---|
| Two grave lot | Upright monument (overall) | - | - | up to 48 in | Monuments up to 4' high must be 8" thick. |
| Two grave lot | Upright monument (base) | up to 36 in | up to 20 in | - | Bottom base 3' long (side to side) by 1'-8" wide (front to back). The bylaw also lists a base size of 3'-0" x 0-8" x 1'-2". |
| Two grave lot | Upright monument (headstone / die) | up to 30 in | at least 8 in | - | Die (diestone) up to 2'-6" long on a 3' base. |
| Three grave lot | Upright monument (overall) | - | - | up to 60 in | Monuments from 4' to 6' high must be 10" thick. |
| Three grave lot | Upright monument (base) | up to 54 in | up to 22 in | - | Bottom base 4'-6" long by 1'-10" wide. The bylaw also gives a maximum base of 4'-6" x 0-8" x 1'-2". |
| Three grave lot | Upright monument (headstone / die) | up to 48 in | - | - | Die up to 3'-0" on a 3'-6" base, 3'-6" on a 4'-0" base, 4'-0" on the maximum 4'-6" base. |
| Four grave lot | Upright monument (overall) | - | - | up to 72 in | Monuments from 4' to 6' high must be 10" thick. |
| Four grave lot | Upright monument (base) | up to 72 in | up to 22 in | - | Bottom base 6' long by 1'-10" wide. The bylaw also gives a maximum base of 6'-0" x 0-8" x 1'-2". |
| Four grave lot | Upright monument (headstone / die) | up to 60 in | at least 10 in | - | Die up to 4'6" on a 5' base and 5' on the maximum 6' base. 10" thickness applies to monuments 4' to 6' high. |
| Monument areas with lots larger than four graves | Upright monument (overall) | - | up to 22 in | up to 72 in | Base length may not exceed 50% of the lot width; max_t is the bylaw's 1'-10" base limit. |
| Exception lots where small upright monuments are permitted (Section C, Sections i and ii) | Upright monument (overall) | - | at least 6 in | up to 36 in | Bottom of the base 2' long by 1' wide (base: w 24", t 12"). |
| Exception lots - hickey markers | Upright monument (overall) | - | at least 6 in | up to 20 in | Thickness measured at the base of the die. |
| All monuments | Upright monument (base) | - | - | 8 in | Bases must be 8" high, same material as the die; bottom 4" rock-pitch finish. High bases over 25% of total height need special approval. |
| Foot of each grave on monument lots | Flat marker | up to 24 in | - | - | Head-to-foot length up to 12" (24" x 12"). Set at the end of the grave farthest from the monument. |
| Two adjoining single graves held by one holder | Flat marker | up to 48 in | - | - | Face area including the base up to 48" x 18" (18" head-to-foot), at the head of the grave. |
| Single grave of 27 sq ft or more | Flat marker | up to 28 in | - | - | Face area including the base up to 28" x 18" (18" head-to-foot). |
| Single grave of 24 sq ft | Flat marker | up to 28 in | - | - | Face area including the base up to 28" x 16" (16" head-to-foot). |
| Infant grave | Flat marker | up to 12 in | - | - | Face area up to 12" x 10" (10" head-to-foot). |
| Small child's grave | Flat marker | up to 16 in | - | - | Face area up to 16" x 10" (10" head-to-foot). |
| All graves - granite flat markers | Flat marker | - | 4 in | - | Stone thickness, 4" throughout. Tolerance of 1/4" over or under is allowed. |
| All graves - bronze flat markers | Flat marker (base) | - | 3 to 4 in | - | Concrete or granite base; granite bases need a 2" border. |
| Feature walls | Memorial (plaque) | up to 24 in | - | up to 18 in | One dark-brown bronze marker, 18" high x 24" wide face area, square-cut edges; h is the plaque's height on the wall. |
Width is side to side, thickness is front to back, height is above the ground.
Ask our assistant about your plot
Monument rules in plain English
- These by-laws (2022 revision) cover all three Pinecrest Remembrance Services cemeteries: Pinecrest Cemetery, Highland Park Cemetery and Merivale Cemetery.
- No monument or marker may be placed until all charges are paid, the Interment Rights Certificate is issued, and the General Manager approves the design, material, construction and location.
- Upright monuments are not allowed on single graves, urn spaces or no-monument lots unless your certificate says otherwise. Only one monument per lot, and none over a grave that already has an interment.
- Two-grave lot: up to 4 ft high, bottom base up to 3 ft long x 1'-8" wide, die up to 2'-6" long. Monuments up to 4 ft high must be 8" thick.
- Three-grave lot: up to 5 ft high, bottom base up to 4'-6" x 1'-10", die up to 4 ft long. Four-grave lot: up to 6 ft high, base up to 6 ft x 1'-10", die up to 5 ft. Monuments 4 to 6 ft high must be 10" thick.
- Lots bigger than four graves: base no longer than half the lot width; nothing over 6 ft high. The die (or any part) can't be as long or as wide as the base.
- In the exception sections where small uprights are allowed: up to 3 ft high, base 2 ft x 1 ft, at least 6" thick. Hickey markers up to 20" high and at least 6" at the base of the die.
- All markers, mausoleums and tombs must be granite; flat markers may be granite or bronze. Marble is only allowed indoors. Bases must match the die, be 8" high with a 4" rock-pitch bottom; rough rock bases are not accepted.
- Dies, columns and crosses must be dowelled with a 6" long, 5/8" stainless steel or aluminum dowel. Free-standing crosses must be at least 8" thick. No uncovered vertical joints.
- No open urns as part of a monument and no vase holes drilled in bases. Cairns, boulders and statuary need Board approval; granite benches may be allowed if the design is approved.
- The Company builds all monument foundations at your expense (concrete pad 4" bigger than the base on piers at least 60" deep). Wrong dimensions on the signed application mean the foundation is removed at your cost.
- Flat markers: one at the end of each grave farthest from the monument, up to 24" x 12"; or one in the monument space instead of a monument.
- Flat marker sizes: two adjoining graves 48" x 18" at the head; single grave of 27 sq ft or more 28" x 18"; single grave of 24 sq ft 28" x 16"; infant 12" x 10"; small child 16" x 10" (face area including base).
- Granite flat markers must be 4" thick; bronze markers go on a 3"-4" concrete or granite base (2" granite border). Turn-down vases set in front of the marker are allowed; no vase openings in the marker.
- All flat markers are set by Company staff. A 1/4" tolerance over or under the specified sizes is allowed.
- Feature wall markers: one dark-brown bronze plaque 18" high x 24" wide. Section and lot number (max 1/2" high) must appear on the lower right corner of every memorial.
- Photo ceramics need the rights holder's written consent. Bronze or granite corner posts 6" square are allowed only on lots of 60 sq ft or more.
- Always confirm with the cemetery office before ordering.
Read the full bylaws (on the cemetery's website)
Bylaws can change and some are read automatically. Always confirm sizes with the cemetery office before ordering. Monaco Monuments checks your cemetery's rules for you as part of every order.
Ready to start? Fill out our free intake form (no cost or obligation) or call us at (905) 392-0778. Fill out the intake form